![cover desk sheet rock cover desk sheet rock](https://i5.walmartimages.com/asr/222135d0-8f58-47bd-809e-f1dda129d515_1.535294db0e6809696e49cba4acc719e0.jpeg)
However, you need to transfer the mass of this structure (and anything placed upon it) downwards. What you really want to do is to support what is a large shelf, off the floor, without any "legs" at the front. However, you believe that you have insufficient "studs" behind the wall to support the mass of the desk in question. You'd be a lucky man if this turned out to be the biggest mistake you make in your lifetime.Ĭan you put that desk in an unfinished garage where you can see the studs it will mount on?Ĭlick to expand.You have a a new desk built out of metal, welded all together.
Cover desk sheet rock how to#
If you don't have studs in the wall to mount it on, or your confidence in what you have is low, then your next step is to figure out how to make that desk free standing. I think you're only real option now is to make that desk free standing. You're going to be leaning on that desk when you write on it, and that movement isn't going to help your wall support that desk any. That's especially true since it won't be a dead weight. If your studs aren't up to snuff, then your 150 pound desk is going to start pulling your wall down. I've seen more than my fair share of studs that are split and twisted, or where the stud is split at the floor or ceiling where it was nailed in. You don't know what condition those studs are in. In my mind 150 pounds is too much weight to reasonably hang on a wall even if you drove your fasteners into the studs. Studs are not an option, of you want to know why check above. TL R, I need to mount a desk made of metal which itself weighs 150lbs and want to hold 500lbs sturdily. I don't have the money to spend on a new stud finder as ive already invested way too much in this project. The house was built in 1960 and even the outlets aren't on studs (not sure how they are mounted). I was checking the studs in the walls today, which are 1/2 in drywall, and there are only two studs on a wall that is almost 9 ft long? I'm confused, although the studs may be metal, the stud finder couldn't find them and neither could a long nail and hammer (couple dozen holes in the walls). It will only hold monitor speakers and body weight of me leaning on it. Big problem, I didn't check for studs before I built the desk, now I have a fully built metal desk that weighs over 150lbs itself. Anyways, I planned on mounting it to the studs, no problem right? I'll make some L brackets and mount it on. The only way I want this desk, is to be mounted to the wall, if it's not mounted to the wall then I just spent lots of money on metal for no reason. So I had this amazing great idea to build a new desk out of metal, welding it all together.